RHP 1117-16 Radial Insert Ball Bearing - 16 mm ID, 40 mm OD, 27.38 mm Width Aetna 63 Seal Design Code

63 Seal Design Code

The puller for tie rods and push rods of the series 129 is used for the hydraulic pressing out of the ball pins when removing ball joints on push and tie rods specifically designed for trucks and low-floor buses

The Whittet-Higgins SC-40A is a two-piece (split) shaft collar machined to inch dimensions

and construction applications

The Whittet-Higgins CNB-06 is a one-piece

RHP 1117-16 Radial Insert Ball Bearing - 16 mm ID, 40 mm OD, 27.38 mm Width Aetna 63 Seal Design CodeRadial Insert Ball Bearing RHP radial insert ball bearings (Y bearings) are deep groove ball bearings with extended inner rings, convex outer surfaces, and integrated seals. They are designed to be mounted in housings to form bearing units and allow some initial misalignment.