FAG 6230-M-J20AA-C3 Deep Groove Ball Bearing - 150 mm ID, 270 mm OD, 45 mm Width OBD The ball joint extractor with

The ball joint extractor with lever translation from the series 129 is used for pressing out ball pins when removing ball joints as well as tie rod ends on tie rods for passenger cars and light commercial vehicles

Multi-component Kraftform handle optimised to withstand pressure

helping reduce manual lubrication work while protecting equipment from under-lubrication

and long-term performance under demanding operating conditions

The AT-100 shaft alignment solution is the result of almost 40 years of shaft alignment expertise and innovation

FAG 6230-M-J20AA-C3 Deep Groove Ball Bearing - 150 mm ID, 270 mm OD, 45 mm Width OBD The ball joint extractor withDeep Groove Ball Bearing FAG deep groove ball bearings are versatile, robust, and accommodate radial and axial loads in both directions. Their simple design, low friction, and high speed capability make them suitable for a wide range of industrial applications, from electric motors to gearboxes. Sealed and shielded variants protect against contamination, while open versions allow easy lubrication.